Heritage Cases

The South African Radio Astronomy Observatory (SARAO) spearheads South Africa’s activities in the SKA Radio Telescope through engineering, science and construction. SARAO is a National Facility, managed by the National Research Foundation, which incorporates radio astronomy instruments and programmes such as the MeerKAT and KAT-7 telescopes in the Karoo, the Hartebeesthoek Radio Astronomy Observatory (HartRAO) in Gauteng, the African Very Long Baseline Interferometry (AVN) programme in nine African countries, as well as the associated human capital development and commercialisation endeavours. Connectivity is required between the SKA core site in the Northern Cape and a data processing facility in Cape Town to transport the science data for the SKA project and its precursor, MeerKAT. Access to dark fibre is required to transport this data due to the expected data throughputs for the SKA project. SARAO has built an overhead fibre route between Carnarvon and the SKA core site. Additionally, the South African National Research Network (SANReN) has procured access to fibre between Beaufort West area and Cape Town. A fibre optic cable connection must, therefore, be built between Carnarvon and Beaufort West. The details of the preferred and selected SKA fibre route (Route A) is as follows: The fibre route starts from Beaufort West Transnet building, to a 3 m x 6 m signal repeater station at Loxton, and then on to the Carnarvon SKA Point of Presence (PoP) site (location where networking equipment may be accessed). The fibre duct and cable will be laid in a 1 m deep and 300 mm wide trench and be buried by backfilling and compacting the trench. The full fibre route will be installed within the road reserves of roads R381 and R63, and 1 m from the fence of the private land. 155 km will be underground and 25 km will be overhead due to it not being technically or financially feasible to trench on the Molteno Pass section. The total pole length is 9 m, buried 1.5 m deep, with a resultant above-ground height of 7.5 m There are several streams / rivers and associated wetlands to cross. Rivers will be crossed using directional drilling 2 m below the riverbed starting 32 m away from river banks. There is only one river with solid bedrock (the Brak River near Loxton) where directional drilling is not technically or financially feasible. Here the fibre cable will be attached to the existing road bridge.